WALL MOUNTED ELECTRIC FIREPLACE HEATER ! OWNERS MANUAL MODEL #: 101002,111002, 101003, 111003 33”/36"/50" Wall Mounted Electric Fireplace AC 120V 60Hz 1500W WARNING Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could result in fire, electric shock, or serious personal injury. CAUTION Keep this owner’s manual for future reference.
IMPORTANT SAFETY INFORMATION! WARNING l Read all instructions before using this heater! l This heater is hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater, and keep them away from the sides and rear.
l ALWAYS turn this heater off before unplugging it from the outlet. l ALWAYS disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace. l NEVER leave this heater unattended. ALWAYS unplug this heater when not in use. l ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet. l NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or connections.
Parts and Hardware B – Wood Screws C – Drywall anchors Remote Control Instruction Manual A – Fireplace E - Wall Bracket Fixed on back of firebox F-Decorative Pebbles G-Decorative Crystals H - Log set I - Plastic Tray Installation and Assembly Your appliance is a wall-mounted appliance. Select a suitable location that is not susceptible to moisture and is away from drapes, furniture and high traffic areas. NOTE: Follow all National and local electrical codes.
Wall Mounted Installation Due to the many different materials used on different walls, it is highly recommended that you consult your local builder before you install this appliance on the wall. A.Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible materials such as curtain drapes, furniture, bedding, paper, etc. B.Have two people hold the appliance against the wall to determine the final location. C.Place unit face down on a soft, non abrasive surface.
WS-G-01,WS-G-03,BEF-36WMC Illustrated Logset / Crystal / Pebble Ember Installation (NOTE:Please make the installation according to the embers which you bought or selected.) A. Glass front must be removed and the appliance must be mounted in its final location before the logset / crystal / pebble embers are installed. B. If your fireplace come with logset, you do not need to do anything, just use as it is. Figure 1. C.
Figure 3. (Crystal medias) Figure 3. (Pebbles medias) Operation Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death. Power Plug the power cord into a 110~120 Volt 15 Amp grounded outlet (see IMPORTANT SAFETY INFORMATION on Pages 2 and 3). Make sure the outlet is in good condition and that the plug is not loose.
Control Panel & Remote Control Operation ON ON (l). Enables all functions. OFF OFF (O). Turns off all functions on control panel and remote control. 1. Press ON (l). Power turns on. All functions are enabled. 2. Press OFF (O). Power, flame effect, and all functions turn off. NOTE: WS-G-01/WS-G-03 come with a ON/OFF switch, before using the appliance, you need to turn it to ON. BUTTON FUNCTION POWER ON: Enables control panel functions and remote control. Turns on flame effect.
Temperature Limiting Control This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the heater will automatically turn OFF. To reset: 1. Unplug the power cord from the outlet. 2. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes. 3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a vacuum to clean the vent areas. 4.
Maintenance Risk of electric shock! DO NOT OPEN any panels ! No user-serviceable parts inside! ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Electrical and Moving Parts: • The fan motors are lubricated at the factory and will not require lubrication. • Electrical components are integrated in the fireplace and are not serviceable by the consumer.
Limited Warranty J & J Global (Seller) warrants to the original Buyer only, that each product will be free from defects in material and workmanship for a period of one (1) year from date of purchase. SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP.
