WT-300 Bass Amplifier The Traveler Owner’s Manual 9/30/98 1
Congratulations on your purchase of the Eden WT-300 Traveler Bass Instrument Amplifier. You have purchased what we feel is one of the finest bass amplifiers in the world. The WT-300 produces 300 watts of pure power into 4 ohms (175 watts into 8 ohms) with 3db of dynamic headroom. The tube preamp section, with its enhance control, powerful quasi-parametric tone control system, and gentle auto -compression circuit allow you to achieve a wide array of sounds.
FRONT PANEL FEATURES EQ Clip Indicator – Flashes to indicate Input Jack – Designed to accept a clipping within the tone control circuit of the preamplifier. This should never be lit up. standard ¼ inch mono phone plug. For best results, use a high-quality, shielded cable to connect your instrument to the amplifier.
compressor and enhance control and prior to the tone section. OPERATING INSTRUCTIONS Recording Out – This fully balanced XLR MECHANICAL AND THERMAL ISSUES – Your amplifier should always be output allows you to send a post-EQ/premaster signal to a recording or sound reinforcement mixing console. This output is designed to allow use with phantom powered systems. D.I. Level – Controls the level being sent from the XLR balanced output jack.
your lower strings. If the action of the compressor seems premature or excessive for your taste, you can lower the gain control a bit to delay the onset of compression. Having set your initial level, you are now ready to proceed with setting up your tone controls. Since tone adjustments have an impact on the overall preamp gain level, you may well need to return to the gain control and repeat this process once you have completed your EQ adjustments.
accommodate the characteristics of your amplifier and your predominant application. If you will only be using one cabinet, a 4 Ohm model will draw the most current from your amplifier. If you will generally be using two cabinets, they should be 8 Ohm models so their combined impedance will be 4 ohms. If you are uncertain about your future needs always go with the 8 Ohm speaker option so that you can add another speaker later if you need to.
EQ Settings Setting name: _____________________ Setting name :___________________ Setting name: _______________________ 7
