Operation Manual

UN PROBLEME ? 8
N’hésitez pas à nous appeler sur notre ligne d’assistance téléphonique (tel en fin de notice).
Nos techniciens se feront un plaisir de vous aider à parfaire votre installation.
message.
VI. Erase Messages
 To erase a particular stored message,
follow the steps below:
Step 1. Press “REC” key when the Dialer is in
Normal Mode to enter Recording mode.
YELLOW LED flashes.
Step 2. Enter “Message Number” (1 or 5).
Step3. Press “CLR” to erase that message and
the Auto Dialer will sound 2 short beeps
to indicate successful deletion.
 To erase all stored messages:
Step 1. Press “REC” key when the Dialer is in
Normal Mode to enter Recording mode.
YELLOW LED flashes.
Step 2. Press “0”
Step 3. Press “CLR” again to hear 2 short beeps
to indicate successful deletion.
Testing your Dialer
I. Test Dial the Telephone Numbers
I. Test Dial the Telephone Numbers I. Test Dial the Telephone Numbers
I. Test Dial the Telephone Numbers
for Reporting
for Reportingfor Reporting
for Reporting
 To test dial the telephone numbers, follow
the steps below.
Step 1. Press “TEST” key when the Dialer is in
Normal Mode to enter Test mode.
The YELLOW LED starts to flash.
Step 2. Enter “Priority Order Number” (11~16
or 21, 22, 31, 32, 41, 42).
The Dialer will dial the phone number as
instructed and play the message
accordingly.
The RED LED lights up during dialing
and reporting.
<
<
N
N
O
O
T
T
E
E
>
>
 To identify line failure make sure
message have been recorded and that
you have stored a telephone number to
test dial
 Test timer is 85 seconds
I
II
II
II
I.
. .
. Test Play the Messages
Test Play the MessagesTest Play the Messages
Test Play the Messages
 To test play one particular message:
Step 1. Press “TEST” key when the Dialer is in
Normal Mode to enter Test mode.
The YELLOW LED starts to flash.
Step 2. Press “0”
Step 3. Enter “Message Number” (1 ~ 5).
The Dialer will playback the recorded
message as instructed.
The RED LED lights up while the
message is played.
 To test play all recorded messages:
Step 1. Press “TEST” key when the Dialer is in
Normal Mode to enter Test mode.
The YELLOW LED starts to flash.
Step 2. Press “0”
Step 3. Press “0” again and the Dialer will play
back all recorded messages in the order
of its Message Number.
The RED LED lights up while the message is
played.
III. Range Test
III. Range TestIII. Range Test
III. Range Test
Step 1. Press “TEST” key when the Dialer is in
Normal Mode to enter Test mode.
The YELLOW LED starts to flash.
Step 2. Press “＊
＊＊
＊”
The Dialer enters “Range Test” mode.
Both LEDs start to flash together.
Step 3. Send a signal from the Control Panel to
the Auto Dialer.
The Dialer will play a short tune twice to
indicate it has successfully received at
this distance range.
Step 4. Press “CLR” to exit Test mode.