Operation Manual

UN PROBLEME ? 7
N’hésitez pas à nous appeler sur notre ligne d’assistance téléphonique (tel en fin de notice).
Nos techniciens se feront un plaisir de vous aider à parfaire votre installation.
received.
Step 3. Key in phone number (max. 20 digits) and
follow by pressing “ ” to complete.
<
<
N
N
O
O
T
T
E
E
>
>
 The maximum length of a number is 20
digits including “＊
＊＊
＊“ & “#”.
 During entering the number, pressing
“CLR” will abort this process and the
Dialer returns to Normal Mode.
 Special Characters for Setting
Two special keys “＊
＊＊
＊“ & “ # ” are
provided to help you to store the
number:
 “＊
＊＊
＊”represents a 3 seconds delay or
pause and the Dialer will not dial “＊
＊＊
＊”.
 “#”represents a 3 seconds delay or
pause and the Dialer will dial “# “ if it is
entered as the last digit of the phone
number.
 Storing a pager number
Pager number – “＊
＊＊
＊“ - “# “ – Identity
code – “# “ - “OK “
The Identity code is a number that
you can key in at your discretion.
This enables the recipient to know
the call is from the Auto Dialer.
You can choose to use any number of
“＊
＊＊
＊“ or “# “ to match the protocols of
the pager system used in your area.
 Storing a Telephone Number in
EPABX phone system
EPABX Access code 0/9/8 –“＊
＊＊
＊“– Tel.
Number – “OK”
You can add as many “＊
＊＊
＊“ as
required.
 Storing a Telephone Number with
extension number
Tel number – “＊
＊＊
＊“ – “＊
＊＊
＊“ – extension
number – “OK”
You can add as many “＊
＊＊
＊“ as
required.
II. Change Telephone Numbers
To edit the telephone numbers, follow the steps as to
store the telephone numbers described in previous
section and enter the new phone numbers to override
the programmed numbers.
III. Delete Telephone Numbers
To delete the telephone numbers, follow the steps as to
store the telephone numbers described in previous
section and press “ ” without entering any new
phone numbers.
IV. Record Messages
CTC-729 offers a total of 20-second Voice Recording
Time and it is divided into 2 messages numbered as
below:
Message#1: Burglar (3 seconds)
Message#2: Fire (3 seconds)
Message#3: Panic (3 seconds)
Message#4: Medical (3 seconds)
Message#5: Common Address (8 seconds)
To record these messages, follow the steps
below.
Step 1. Press “REC” key when the Dialer is in
Normal mode to enter Recording mode.
YELLOW LED flashes.
Step 2. Enter “Message Number” (1 or 5).
Step 3. Press “REC” again to hear a long beep
and the RED LED lights up.
Step 4. Start to record your message and press
“CLR” when done or wait for the timer to
run out.
V. Edit Messages
To edit the messages, follow the steps as to store
the messages described in previous section and
record a new message to overlap the stored