Operation Manual

UN PROBLEME ? 6
N’hésitez pas à nous appeler sur notre ligne d’assistance téléphonique (tel en fin de notice).
Nos techniciens se feront un plaisir de vous aider à parfaire votre installation.
“7” for Pin 1
Step3. Enter “Polarity Designated Number”
“0” for “ - “ polarity (Default)
“1” for “ + ” polarity
Step 4. Press “CLR” to exit to Normal mode or the
Auto Dialer will automatically exit this
mode when 5-second time out is up.
V. Getting Started
 Learn HA2000RTC
Step 1. Put the Dialer in Learn Mode by pressing
“TEST” and “9”. Yellow LED will start to
flash.
Step 2. Please enter the submenu “Program
Siren” of “Devices +/-“ from the Control
Panel HA2000, then select “Learn Siren”,
press “OK” to send a signal to the Auto
Dialer (HA2000RTC).
Step 3. The Auto Dialer will recognize the signal
as the learn code and sound one long
beep and two short beeps to indicate the
learning process is completed
Step 4. Press “CLR” on the Auto Dialer to exit
Learn Mode.
<
<
N
N
O
O
T
T
E
E
>
>
 The learning code is stored into
EEPROM and will not be lost during
power failure.
 The Auto Dialer will sound 2 sets of
continuous 2 beeps if the Learning Code
has been received previously.
 The Auto Dialer automatically exit Learn
Mode after a 3-minute Time Out.
 By Pressing “TEST”, “9” and “*”, Control
Panel will be removed from the Auto
dialer..
 Learn HA2000SOS
Step 1. Put the Dialer in Learn Mode by pressing
“TEST” and “9”. Yellow LED will start to
flash.
Step 2.
Press the button on HA2000SOS to
transmit the signal.
Step 3. The Auto Dialer will recognize the signal
as the learn code and sound one long
beep and two short beeps to indicate the
learning process is completed
<
<
N
N
O
O
T
T
E
E
>
>
 Iif the HA2000RTC has been learnt in,
you must remove it to learn HA2000SOS,
and vice versa.
 The Auto Dialer will sound 8 short beeps
indicating either HA2000SOS or Control
Panel has been learnt-in and must be
removed first.
 By Pressing “TEST”, “9” and “*”,
HA2000SOS will be removed from the
Auto dialer..
Configuring your Dialer
I. Store Telephone Numbers
To store the telephone numbers, follow the steps
below.
Step 1. Press “ ” key when the Dialer is in
Normal mode to enter Programming
mode.
The YELLOW LED will flash.
Step 2. Enter “Priority Order Number” (1~6).
Select Your Priority Order Number:
A) By Singular Sequence:
11, 12, 13, 14, 15, 16
B) By Alarm Event:
1) Burglar/Panic/Technical:
21, 22
2) Fire/ Gas: 31, 32
3) Medical: 41, 42.
 If the Priority Order Number is selected by
Alarm Event, the Dialer will dial the
programmed phone number depending on
the type of alarming signal received.
 No
 If no phone number has been stored for a
particular Alarm Event, the dialer will
automatically dial in sequence of other
available Alarm Event phone numbers in
regardless of the original Alarm signal