Operation Manual
UN PROBLEME ?
5
N’hésitez pas à nous appeler sur notre ligne d’assistance téléphonique (tel en fin de notice).
Nos techniciens se feront un plaisir de vous aider à parfaire votre installation.
10. Battery Compartment
For 4 x D-cell Alkaline Batteries.
11. Phone jack marked “Line”
This jack is for the connection to the phone line
from the wall.
12. Phone jack marked “Phone”
This jack is for the connection to the Telephone
unit.
13. Device Connection Terminal
The 2-Pin Device Connection Terminal is for
connecting to wired detectors
II. The Power Supply
CTC-729G Auto Dialer features completely wire-free
operation and uses four alkaline D cells. The battery-
life is estimated for 2 years or more.
Battery Insertion:
The battery compartment is a large box in the Control
Panel with a lid secured with 1 screw.
Remove the screw and take off the
compartment lid.
Insert the D cell alkaline batteries provided
into the battery compartment, taking care to
put the batteries in the right way around.
The unit will give a long beep when the last
battery is inserted.
Replace the battery compartment with the
screw taking care not to over tighten
Close the lid and tighten the large lid fixing
screw with a coin.
III. Connecting the telephone line
Two telephone jacks can be found from the rear for the
connection of your telephone line and telephone set.
Remove the Wall Mounting Bracket as
shown.
Plug one end of the enclosed telephone cable
into the socket jack on the wall.
Plug the other end of the enclosed telephone
cable into the socket marked “Line”.
Plug your telephone set into the other socket
marked “Phone”.
IV. Device Connection Terminal
Pin 1 provide Dry Contact input for wired
detector
For wired PIR detectors, Door Contact, Water
detectors, Panic buttons and Broken Glass
detectors, connect Pin 1 to Pin 2
To Set Terminal Polarity
The polarity of the Device Connection Terminal can be
set following these steps:
Step 1.
Press “ ” key when the Dialer is in
Normal Mode to enter Programming
mode.
The YELLOW LED will flash.
Step 2. Enter “Pin Designated Number”