Dialler HA2000 RTC Installation & Operating Manual
The easiest way to get to know the system and get it up and running quickly is to get all the devices and accessories programmed on a tabletop before locating and mounting them. Kit Contents The Alarm System HA2000 should contain the following components: 1 x RTC Dialler HA2000RTC when in Test Mode. Yellow LED flashes every 3 seconds to indicate Report Faillure. Yellow LED flashes every 30 seconds to indicate Low Battery 2.
10. Battery Compartment For 4 x D-cell Alkaline Batteries. 11. Phone jack marked “Line” This jack is for the connection to the phone line from the wall. 12. Phone jack marked “Phone” This jack is for the connection to the Telephone unit. Two telephone jacks can be found from the rear for the connection of your telephone line and telephone set. 13.
“0” for “ - “ polarity (Default) Step 3. The Auto Dialer will recognize the signal as the learn code and sound one long beep and two short beeps to indicate the learning process is completed “1” for “ + ” polarity “7” for Pin 1 Step3. Enter “Polarity Designated Number” Step 4. Press “CLR” to exit to Normal mode or the Auto Dialer will automatically exit this mode when 5-second time out is up. V.
received. Step 3. Key in phone number (max. 20 digits) and follow by pressing “ ” to complete. II. Change Telephone Numbers The maximum length of a number is 20 digits including “＊ ＊“ & “#”. During entering the number, pressing “CLR” will abort this process and the Dialer returns to Normal Mode. Special Characters for Setting Two special keys “＊ ＊“ & “ # ” are provided to help you to store the number: “＊ ＊”represents a 3 seconds delay or pause and the Dialer will not dial “＊ ＊”.
you have stored a telephone number to test dial message. VI. Erase Messages Test timer is 85 seconds To erase a particular stored message, follow the steps below: II. Test Play the Messages Step 1. Press “REC” key when the Dialer is in Normal Mode to enter Recording mode. To test play one particular message: YELLOW LED flashes. Step 2. Enter “Message Number” (1 or 5). Step3. Press “CLR” to erase that message and the Auto Dialer will sound 2 short beeps to indicate successful deletion.
receives a Disarm signal from the Control Panel, the Dialler will ignore it and continue the dialing process. Correct the distance range to allow the Dialer to be within the transmission range of the Control Panel if Dialer is unresponsive to the signal. If no signal is received in 3 minutes, the Auto Dialer automatically exits Test mode and returns to Normal mode Operation 1.
him/her to listen into what is happening on your side through the microphone & speaker on the unit. The Communication channel, once opened, lasts for 3 minutes. The recipient will hear repeated beep sound 15 second before the Dialer hangs up the line. Step 3. Listen to 2 beeps from the receiver. Step 4. Press PIN Code (0000) and if the operations were successful dialer will hear a long beep Step 5.
Put the dialer in test mode. Correct the distance range to allow the Dialer to be within the transmission range of the Control Panel if Dialer is unresponsive to the signal. Using the 2 holes of the Wall Mounting Bracket as a template, mark off the holes’ positions. Drill 2 holes and fix the screws & plugs provided. Hook the HA2000RTC unit onto the Wall Mounting Bracket (holding the unit with the front facing you).
