Installation manual

©2014 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. 9/19/14 - QT/mc
Edelbrock E-Force Supercharger System
2010-2014 Camaro SS
Installation Instructions
Page 3
91 octane or higher gasoline is required at all times. If your vehicle
has been filled with anything less, it must be run until almost dry and
refilled with 91 or higher octane gasoline twice prior to installation.
Failure to use the required 91 octane gasoline or higher could
permanently damage your engine. Any failures associated with not
using premium 91 octane gasoline or higher, will be ineligible for
warranty repairs.
IMPORTANT WARNINGS (CONTINUE)
Edelbrock Authorized Installer Disclaimer
Authorized installers of Edelbrock products are independent companies over which Edelbrock has no right of control. Edelbrock LLC makes
no claims regarding the abilities, expertise or competency of individual employees of any authorized installer. Each authorized installer is
an independent company and makes its own independent judgments. Edelbrock LLC specifically disclaims any responsibility to any party
including third parties for the actions, or the failure to act, of individuals, agents or a company authorized in the installation of Edelbrock LLC
products.
Edelbrock periodically releases improved versions of the calibration file found on the supplied handheld
programmer. It is recommended to check the website, www.edelbrock.com, to ensure you have the
latest version as described in the PCM Flashing Procedure on Page #9.
It is also recommended that you check the Edelbrock Tech Center Website for any updates to this
installation manual. Please refer to the lower right hand corner to verify that you have the latest revision
of this installation manual before beginning the installation.
Tech Center: http://www.edelbrock.com/automotive_new/misc/tech_center/install/index.php