Installation manual

©2014 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. 9/19/14 - QT/mc
Edelbrock E-Force Supercharger System
2010-2014 Camaro SS
Installation Instructions
Page 18
109. Secure the top of the heat exchanger with the two M8
x 20mm bolts supplied in Bag #2 and tighten them with a
12mm socket.
110. Install the M8 nuts and M8 x 20mm bolts supplied in
Bag #2 into the holes in the lower heat exchanger brackets
then use a 12mm wrench and socket to tighten them.
111. Install the intercooler water pump bracket on the
studs located on the back of the passenger side of the
bumper. Secure it in place with the M8 nuts supplied in
Bag #2 and tighten them with a 12mm wrench.
112. Install the water pump to heat exchanger hose on the
passenger side inlet fitting of the heat exchanger and clock
it until it contacts the lower radiator shroud. Secure the
fitting with a 3/4” hose clamp supplied in Bag #2.
113. Slide the strap over the body of the water pump and
install it in the water pump bracket. Rotate the water pump
and slide it in and out until it roughly lines up with the
position of the hose on the other side of the lower radiator
shroud.
114. Use a Unibit to drill a 1-1/8” hole in the lower radiator
shroud to allow the hose to slide onto the water pump outlet
fitting. Please note that 2014 Model Years will have a
different hole location just left of the LTR.
2014 Model Year
2010-13 Model Year
115. Use the supplied bolt and a 13mm socket to secure
the water pump by tightening the strap to the bracket.
116. Slide the hose onto the water pump outlet and secure
it with a 3/4” hose clamp supplied in Bag #2.
117. Install the Intercooler Hose Assembly by sliding it
down between the radiator fan assembly and the engine.
Note that the short hose section will go around the radiator
to the outlet of the heat exchanger.