Installation manual

Part #1596, 1597, 1598, 1599

Brochure #63-1598

Rev. 9/19/14 - QT/mc

Edelbrock E-Force Supercharger System

2010-2014 Camaro SS

Installation Instructions

Page 15

71. Install the supplied Heater Core Hose Assembly to the

firewall fittings using the supplied hose clamps. Route the

lines between the engine oil dipstick and the fuse box to the

fittings on the water pump and secure them with the

supplied hose clamps. Note that the hose closer to the

passenger side of the firewall will be routed to the fitting

closer to the front of the vehicle and vice versa.

72. Apply Blue Loctite, or equivalent, to the threads of the

M8 x 20mm bolt supplied in Bag #1 then use a 12mm

socket and washer to install the smaller supplied idler pulley

onto the supplied idler bracket.

73. Use a 10mm socket to remove the three water pump

bolts indicated.

74. Apply blue Loctite, or equivalent, to the threads of the

M8 x 100mm bolts supplied in Bag #1 then use a 6mm

Allen tool to install the idler bracket onto the water pump.

75. Use a 15mm socket to remove the nut retaining the

ground strap on the passenger side cylinder head then use

a 15mm deep socket to remove the ground strap stud.

76. Apply blue Loctite, or equivalent, to the threads of the

stock tensioner bolts then use a 15mm socket to install the

supplied tensioner bracket to the water pump.

77. Apply blue Loctite, or equivalent, to the threads of the

M10 x 65mm bolt supplied in Bag #1 then use an 8mm

allen to install it in the countersunk bolt hole of the tensioner

bracket.