Installation manual

Part #1596, 1597, 1598, 1599

Brochure #63-1598

Rev. 9/19/14 - QT/mc

Edelbrock E-Force Supercharger System

2010-2014 Camaro SS

Installation Instructions

Page 11

36. Use a 3/8” Fuel Line Removal Tool to disconnect the

fuel line from the fuel rails and from the passenger side

fender fitting. Use a shop rag to absorb any excess fuel.

37. Use a 10mm socket to remove the nut holding down

the fuel line clamp then remove the fuel line and clamp.

38. Disconnect the two ignition harness connectors, the

eight spark plug wires from the ignition coils and the eight

fuel injector electrical connectors.

39. Use a 10mm deep socket to remove the five studs

retaining each of the ignition coil brackets to the valve

covers. Lift and remove the coil brackets as an assembly.

40. Disconnect the EVAP hose from the EVAP Solenoid and

the EVAP hard line located on the passenger side.

41. Use a 10mm socket to remove the nut on the driver

side and remove the plastic manifold webbing.

42. Use an 8mm socket to remove the manifold bolt on the

driver side retaining the fuel rail bracket.

43. Use a 10mm deep socket to remove the four fuel rail

studs. Remove the fuel rail bracket then remove the rails

by lifting the injectors straight up out of their provisions then

work the rails forward and set them aside.

44. Use an 8mm socket to remove the nine remaining

manifold bolts. Note that the rearmost passenger side bolt

will come out with the manifold and that it is necessary to

rotate the manifold towards the passenger side to remove

the rearmost driver side bolt and the bracket it retains.