Installation manual

©2014 Edelbrock LLC
Part #1574, 1575, 1576
Brochure #63-1574
Rev. 9/24/14 - QT
Edelbrock GM LS3 Supercharger System for
2010 and later Grand Sport Corvettes
Installation Instructions
Page 18
90. Use an 18mm socket to remove the two steering rack
nuts and bolts.
91. Remove the plastic clamp holding the power steering
lines to the steering rack.
92. Loosen the rear engine cradle nuts with a 21mm deep
socket and lower them until there is a gap of 10mm from
the cradle to the top of the nut.
93. Insert a pry bar between the frame and front driver
side cradle mount.
94. Work the power steering rack out through the driver
side wheel well. Use the pry bar to widen the gap when
needed and push the brake lines out of the way to clear
the gearbox.
85. Use a 21mm deep socket to remove the two front
engine cradle bolts.
86. Disconnect the ride height sensor electrical connector
from each side, if equipped.
87. Use a 10mm socket to remove the driver side brake
line bracket bolt.
88. Use a 10mm socket to remove driver side ride height
sensor bolt.
89. Use a 13mm socket to remove the lower brake
modulator bracket bolts.