Owners manual

Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 9
©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Thank you for purchasing the Edelbrock Supercharger System for the Chevy Corvette C7 LT1. The Edelbrock E-Force
Supercharger System for the Chevy Corvette utilizes the same Eaton Gen VI TVS Supercharger rotors but housed inside a
redesigned, low profile, supercharger manifold. The manifold is Edelbrock’s lowest profile supercharger manifold to date.
Paired with short, bolt-on runners, this new package will fit under the factory C7 Corvette hood with no modifications to
the stock body or hood. The supercharger retains the inverted design which expels air upward. Air pressure then builds
in the plenum, before being drawn down through the twin intercooler cores.
This system features a cast water crossover; a first for Edelbrock. This design will simplify the intercooler hose routing.
The water crossover is secured to the manifold, allowing the cooled 50/50 coolant mixture from the LTR (Low Temp
Radiator) to cool down the twin intercoolers housed inside the manifold.
The supercharger is 50-State emissions legal, and includes a 3-year 36,000 mile warranty so that there are no worries
when installing it on a brand new car.
INTRODUCTION
TOOLS AND SUPPLIES REQUIRED
z Jack and Jack Stands OR Service Lift
z Claw-Type Harmonic Balancer Puller
z Harmonic Balancer Installation Tool
z Ratchet and Socket Set including but not limited to:
7mm, 8mm, 10mm (standard, deep and swivel),
11mm, 12mm, 13mm, 15mm, 18mm, 21mm, 24mm
z Wrench Set including but not limited to: 8mm, 10mm,
15mm, 11/16”
z Breaker Bar: 1/2”
z Compressed Air
z Ratchet Strap
z Power Drill
z Drill Bit: 8mm and 1.5” Hole Saw
z Allen Wrenches: 9/64”, 5mm, 6mm, 8mm
z Torx Drives: T15, T30
z Panel Puller
z Flat Blade & Phillips Screwdrivers
z Coolant Drain Bucket
z 50/50 Coolant Mixture
z Mechanic’s Wire
z Side Cutters
z Dremel or equivalent
z 3/8” Fuel Line Removal Tools
z Torque Wrench
z Angle Meter
z GM Flywheel Holding Tool
z Pliers OR Hose Clamp Removal Tool
z Blue, Green and Red Thread Retaining Compound
z O-ring Lube
z Masking Tape
z Shop Rags
z Non-Black Sharpie or equivalent
z Wire Ties