Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 37
160. Turn the hoodliner over so the hood side is facing
upwards, continue the cut just to the top of the horizontal
embossing (see red dotted line from image on Step #153).
DO NOT allow the cut to continue into the embossed area as
it will not secure properly to the hood. The total length of the
cut should be approximately 3.5”. Repeat Steps #157-158
to cut the right vertical embossing.
161. With the hood side of the hoodliner facing upwards,
cut the top horizontal embossing using a straight edge and
sharp utility knife. NOTE: The cut must remain 1-2mm
above the embossing. The final product should look like the
image on Step 160.
162. The finished hoodliner should look like the image
below.
163. Using a measuring tape, mark the horizontal hood
brace 12” from the inside of the vertical hood brace. Do this
for both sides.
12”
164. With the support bracket locations marked, position the
left (driver side) bracket onto the flat portion of the horizontal
support brace, right of the 12” mark.