Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 36
155. Carefully follow the procedure to modify the hoodliner.
The modification consist of partially cutting the hoodliner
along the embossing and securing the modified portion to
the hood. The red dotted line below represents where the
hoodliner has to be cut and secured.
156. Remove two (2) screws using a T-15 Torx screwdriver.
Carefully pull the air duct outwards to release from the
hoodliner.
157. Carefully remove six (6) tree pins using a panel puller.
Lift hoodliner upwards to remove from the hood. NOTE:
Proceed with caution as the hoodliner is easily damaged.
158. Lay the hoodliner on a clean flat working surface with
the engine side facing up. Using a measuring tape and
marker, mark the hoodliner 7” from the air duct opening
along the left and right vertical embossing. NOTE: This
should be done on the engine side of the hoodliner as the
vertical embossing is more pronounced.
7”
7”
Vertical
Embossing
159. Using a straight edge and sharp utility knife, carefully
cut the hoodliner along the left vertical embossing starting
from the 7” mark and slowly working your way down
towards the air duct opening. Once the cut is 3” long, stop
and turn the hoodliner over.