Owners manual

Brochure #63-1570

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 Chevy Corvette C7 LT1 6.2L

Installation Instructions

Page 34

140. Using a 10mm socket and the stock valve cover bolts,

install the side cover brackets to the valve cover. Re-secure

the passenger side coil cover.

141. Using an appropriate cutting tool, trim the driver side

coil covers to clear the supercharger manifold and the fuel

line extension. TIP: It’s recommended to test fit the coil

cover frequently to avoid over trimming the coil cover.

Reinstall the passenger side coil cover once proper fitment

is verified.

142. Using a Torx T15, remove the rear section of the

factory airbox and replace the air filter with the supplied,

reusable, green filter. Reinstall the rear section of the

airbox.

143. Install the supplied grommets and Quick Disconnect

fittings from Bag #4 onto the supplied air inlet tube. NOTE:

Some vehicles do not have the driver side PCV hose

routed to the factory intake tube. In this case, use the

included plastic plug in place of the metal fitting closest

to the throttle body.

144. Install the hump coupler onto the airbox. Install the air

inlet tube onto the airbox and then onto the throttle body

using the straight couplers. Secure with supplied worm

clamps.

NOTE: Some trimming of the tab protruding on the fan

may be required.