Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 33
132. Using two (2) hose clamps from Bag #2, secure the
Recovery Tank to Water Pump hose onto the bottom barb on
the tank and to the inlet barb of the water pump.
133. Connect the previously installed, LTR to Manifold hose,
to the lower barb on the water crossover. Secure hose with
a hose clamp from Bag #2.
134. Connect the Tank to Manifold hose to the upper barb
on the water crossover. Secure the hose with two (2) hose
clamps from Bag #2.
135. Connect the previously installed actuator PCV hose to
the actuator.
136. Using a 10mm socket, remove the throttle body from
the stock manifold and install it onto the supercharger
manifold using the factory throttle body gasket and bolts.
137. Using a 10mm socket, remove the 2nd and 3rd bolt
from the driver side valve cover.
138. Using a Torx T30, loosen the passenger side coil cover
and remove the 2nd and 4th valve cover bolts.
139. Remove the rubber side cover supports from the
factory side covers. Using a little lube, install the rubber
side cover supports onto the supplied side cover brackets.