Owners manual

Brochure #63-1570

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 Chevy Corvette C7 LT1 6.2L

Installation Instructions

Page 32

125. Route the water pump connector down towards water

pump and connect to the water pump.

126. Connect the factory EVAP connector to the EVAP

connector on the water pump harness. Connect the EVAP

connector on the water pump harness to the EVAP solenoid.

TIP: Note connector orientation.

127. Route the fuse and Power connector over towards the

alternator. Using a 13mm socket, remove the nut securing

the power cable and install the water pump power

connector.

128. Secure the Water Pump harness to existing wire looms

and/or hoses away from moving and hot components.

129. Carefully install the 10 rib supercharger belt between

the steering rack and supercharger drive pulley.

130. Position the supercharger belt around the supplied

tensioner and install the tensioner onto the FEAD bracket

using a 15mm socket and a M10 x 90mm Hex Flange bolt.

Torque tensioner bolt to 32 ft-lbs.

131. Using a breaker bar, rotate the tensioner

counterclockwise and install the supercharger belt using

the routing diagram below.