Owners manual

Brochure #63-1570

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 Chevy Corvette C7 LT1 6.2L

Installation Instructions

Page 28

98. Using a 10mm wrench and two (2) M6 x 16mm bolts

from Bag #2, secure the water pump assembly to the

support brace adjacent to the air duct.

99. Using a hose clamp from Bag #2, secure the LTR to

Water Pump hose to the water pump outlet.

100. Reattach the condenser to the radiator and reinstall the

assembly using a 10mm socket. Reinstall the electric fan

using a 10mm socket. Reconnect the lower left accessory

cooler hose and both radiator hoses. Re-secure the lower

radiator hose to the electronic fan. Reconnect electric fan

and A/C condenser connectors.

101. Using a razor blade or equivalent, cut out the fuel line

relief on the foam valley insulator.

102. Reinstall the foam valley insulator into the valley

making sure it is seated properly.

103. Remove the factory O-ring gaskets from the intake

manifold.

104. Clean and inspect the O-ring gaskets. Replace torn or

damage O-rings as needed. Using a razor blade, or

equivalent, remove the tips off all eight (8) factory O-ring

gaskets.

105. Install four (4) modified O-ring gaskets onto the

passenger side E-Force runner. NOTE: Driver side runner

will have a slot for the fuel line, the passenger side

runner will not.