Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 24
60. Disconnect the chassis harness and the brake control
module harness.
61. Raise the vehicle with a service lift or equivalent.
62. Using a 13mm socket, remove two (2) bolts securing
the starter.
63. Remove three (3) bolts securing the starter’s heat
shield using a 10mm socket.
64. Using a 10mm socket, remove the dust cover and
position the starter rearwards to install a GM flywheel
holder. NOTE: Starter does not have to be completely
removed.
65. Using a Torx T15, remove four (4) bolts securing the
passenger side brake cooler duct. Repeat for the driver side
brake cooler duct.
66. Unbolt the driver and passenger sway bar end links
using 8mm and 18mm wrenches.
67. Note the orientation of the sway bar. Using a 15mm
and 18mm socket, remove four (4) bolts securing the sway
bar assembly to the subframe. Carefully remove the sway
bar assembly and set aside.
68. Using a 10mm socket, remove two (2) nuts and
washers securing the brake control module to the support
bracket. TIP: These nuts are easier to remove from the
top. Washers may be stuck to rubber grommets,
carefully remove w/ a small flathead screwdriver.