Owners manual

Brochure #63-1570

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 Chevy Corvette C7 LT1 6.2L

Installation Instructions

Page 23

52. Lower the vehicle and position the LTR into the radiator

shroud cavity making sure the lower mounting brackets

protrude through the holes created in the previous Step.

Verify that the LTR barbs nest into the holes on the driver

side shroud created in Step 48.

53. Raise the vehicle with a service lift or equivalent.

Using a 10mm socket, temporarily secure the LTR to the

radiator support using the factory bolts.

54. Lower the vehicle. Using a drill with an 8mm bit,

carefully drill through the plastic radiator shroud using the

holes on the LTR brackets as guides. Secure the LTR to the

radiator shroud with the supplied push pins from Bag #2.

55. With the LTR installed, temporally reposition the A/C

condenser in its factory location.

56. Using a ratchet strap or equivalent, secure the steering

wheel to prevent it from rotating. WARNING: Damage to

the SIR coil may result from rotation of the steering

wheel and/or front tires once the intermediate steering

shaft is disconnected.

57. Using an 11mm socket, unbolt the intermediate

steering shaft from the steering rack.

58. Support the hood with a sturdy hood prop. Using a

small flathead screwdriver, remove both hood dampers and

set aside.

59. Unplug all three (3) connectors from the electronic

power steering module.