Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 22
44. Disconnect the A/C condenser connector, right of the
radiator, to prevent the connector from getting damaged.
45. Push in the locking tabs on the rear of the radiator to
release the condenser support tabs. Lift condenser upwards
to detach and remove the radiator. The condenser will not
be removed.
46. Using mechanic’s wire, secure the condenser rearwards
to prevent any damage that may occur during installation.
47. Cut out Template #1 Top and Bottom at the end of
these instructions. Tape the two templates together at the
dotted line.
48. Using tape, secure Template #1 to the inside of the
radiator shroud as shown. Using a 1.5” Hole Saw bit, drill
out both circles on the template. With an appropriate
cutting tool, finish trimming the shroud to clear the low
temp radiator (LTR) barbs as marked by the template.
49. Raise the vehicle with a service lift or equivalent.
50. Cut out Template #2 supplied at the end of these
instructions.
51. Using tape, secure Template #2 to the radiator shroud
as shown. Make sure to line up the trimming location to the
mounting holes on the support brace. Using an appropriate
cutting tool, cut the radiator shroud for the LTR mounting
brackets.
Mounting Holes