Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 21
37. Unplug the brake booster check valve harness
connector. Remove the check valve from the brake booster
and from the canister. Set the brake booster hose assembly
aside as it will be reused later.
Harness
Connector
38. Remove the upper and lower radiator hoses with an
appropriate hose clamp tool. NOTE: Factory hose clamps
may be glued to the radiator hoses. Avoid rotating the
hose clamps as radiator hoses may tear.
39. Disconnect two (2) radiator hose support rings from the
fan assembly with a panel remover.
40. Disconnect the overflow/purge tube from the upper
right radiator. Remove the retaining clip from the accessory
cooler return hose, located on the lower left of the radiator,
with a small flathead screwdriver. Remove the hose and set
the retaining clip aside as it will be reused later.
41. Unplug the electric fan assembly.
42. Using a 10mm socket, remove two (2) bolts securing
the fan assembly to the radiator. Lift fan assembly upwards
and remove.
43. Using a 13mm socket, remove two (2) bolts securing
the radiator and condenser assembly.