Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 20
31. Clean the intake port surfaces with a shop rag. Cover
the ports with protective tape to keep out debris. Remove
the black foam insulator from the valley and set aside.
32. Using a Torx T30, remove two bolts securing the driver
side coil cover and remove.
33. Remove the retaining clip on the fuel line. Using a 3/8”
fuel line tool, disconnect the fuel line from the fuel line
extension. CAUTION: Place a shop rag around the fuel
line to prevent fuel from spraying.
34. Using a 10mm socket, remove the bolt securing the
fuel line extension to the valve cover. Remove the retaining
clip on the fuel line extension. Then remove the fuel line
extension from the fuel pump using a 3/8” fuel line tool.
35. Install the supplied fuel line extension onto the fuel
pump barb.
36. Loosely secure the fuel line extension to the valve
cover using the factory bolt. Apply Blue thread locker to the
threads of the fuel line extension lock nut. Using a 11/16”
wrench, secure the fuel line extension to the fuel pump
using the lock nut. Tighten the lock nut, DO NOT OVER
TIGHTEN. Securely fasten the factory fuel line extension
bolt and fasten the set screw using a 9/64” hex wrench.