Owners manual

©2017 Edelbrock LLC
Brochure #63-1570
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 Chevy Corvette C7 LT1 6.2L
Installation Instructions
Page 18
17. Using a 10mm socket, remove three (3) bolts securing
the rear splash guard and remove.
18. Drain the coolant by removing the petcock on the
lower driver side of the radiator.
19. Using a 7mm socket, remove four (4) bolts securing
the factory air duct. Remove air duct and set aside.
20. Disconnect the passenger side and driver side PCV
hoses from the air inlet tube. The driver side PCV can be
removed from the valve cover barb as well. Do not discard
as both hoses will be reused. Note: Some vehicles will
not have the same driver side PCV hose as shown
below. In this case, the driver side PCV hose that runs
across the engine bay should still be removed and set
aside as it will be reused later.
21. Disengage the locking tab on the MAF sensor harness
and unplug the MAF sensor harness.
22. Using a flat head screwdriver, loosen the worm clamps
on the air inlet tube. Remove the air inlet tube from the
throttle body and airbox.
23. Carefully lift up the side engine covers to disengage
and remove.
24. Disengage the locking tab on the MAP sensor harness
and unplug the MAP sensor harness.