Owners manual

Part #1565, 1566, 1519, 15192

Brochure #63-1565

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 GM Truck & SUV 1500

5.3L and 6.2L Installation Instructions

Page 1

Thank you for purchasing the Edelbrock Supercharger System for the 2014-2017 GM 1500 Trucks and SUVs. This

system utilizes the same Eaton Gen VI TVS Supercharger rotors as the previous E-Force supercharger but housed inside

a redesigned supercharger manifold. Paired with bolt-on runners, this new package will fit under the factory hood with

no modifications to the stock body or hood. The supercharger retains the inverted design which expels air upward. Air

pressure then builds in the plenum, before being drawn down through the twin intercooler cores.

This system features a cast water crossover to simplify intercooler hose routing. The water crossover is secured to the

manifold, allowing the cooled 50/50 coolant mixture from the LTR (Low Temp Radiator) to cool down the twin intercoolers

housed inside the manifold.

The supercharger is 50-state emissions legal (pending), and includes a 3-year 36,000 mile warranty, where applicable,

so there are no worries when installing on a brand new vehicle.

INTRODUCTION

TOOLS AND SUPPLIES REQUIRED

z Jack and Jack Stands OR Service Lift

z Ratchet and Socket Set including but not limited to:

7mm, 8mm, 10mm (standard, deep and swivel),

11mm, 12mm, 13mm and 15mm

z Breaker Bar: 1/2”

z Allen Wrenches: 5mm, 6mm, 8mm

z Torx Drives: T15, T30

z Panel Puller

z Flat Blade & Phillips Screwdrivers

z Coolant Drain Bucket

z 50/50 Coolant Mixture (4.5 quarts)

z Side Cutters

z Angle Grinder, or equivalent

z 7/8” Fuel Line Removal Tools

z Drill

z 1-1/4” Hole Saw

z Torque Wrench

z Pliers OR Hose Clamp Removal Tool

z Blue, Green and Red Thread Retaining Compound

z O-ring Lube

z Masking Tape

z Shop Rags

z Wire Ties