Owners manual

Part #1565, 1566, 1519, 15192

Brochure #63-1565

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 GM Truck & SUV 1500

5.3L and 6.2L Installation Instructions

Page 27

119. Secure the water pump harness to existing wire looms

and/or hoses away from moving components and sharp

edges.

120. Install the supplied grommets and Quick Disconnect

fittings from Bag #4 onto the supplied air inlet tube.

121. Install the hump coupler onto the airbox. Install the air

inlet tube onto the airbox and then onto the throttle body

using the straight coupler (6.2L) or the reducer coupler

(5.3L). Secure air inlet tube with the supplied worm

clamps.

122. Install the 90° end of the supplied PCV hose to the

passenger side valve cover. Install the other end to the

fitting on the air inlet tube.

123. Install the 45° end of the supplied PCV hose to the

driver side valve cover. Install the 90° end to the fitting on

the air inlet tube.

124. Fill the supercharger recovery tank with 50/50 coolant

blend. See “How to prime the Edelbrock E-Force intercooler

system guide at the end of these instructions.

125. Reconnect the battery and switch ignition to the ON

position, DO NOT START. With the ignition switch on,

check for any coolant or fuel leaks. Repair all leaks before

proceeding. If no leaks are present the installation is

complete.

Congratulations on the successful installation of your new

Edelbrock E-Force Supercharger System. If you have any

questions, please call our Technical Support hotline at 800-

416-8628 and one of our technicians will be happy to assist

you.