Owners manual

Part #1565, 1566, 1519, 15192

Brochure #63-1565

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 GM Truck & SUV 1500

5.3L and 6.2L Installation Instructions

Page 26

112. Using wire ties, or equivalent, secure the relay on the

water pump harness to the vehicle harness mounted on the

driver side firewall. Route the EVAP and water pump

connectors towards the front of the vehicle following the

hood latch cable. Secure the water pump harness to the

factory hood latch cable loops.

Relay

Cable Loops

113. Using a 10mm socket, remove the nut securing the

factory ground strap left of the brake booster. Install the

GROUND wire on the water pump harness to the ground

strap stud and reinstall the factory nut.

114. Route the POWER wire on the water pump harness to

the power terminal located behind the fuse box. Using a

10mm socket, secure the POWER wire to the terminal.

115. Route the water pump connector down towards to

water pump and the EVAP connector over towards the

EVAP.

116. Connect the factory EVAP connector (ORANGE) to the

water pump harness (BLUE) and connect the water pump

harness to the EVAP solenoid on the supercharger nose.

117. Re-secure the engine harness using the factory

hardware.

118. Connect water pump harness to the water pump.