Owners manual

Part #1565, 1566, 1519, 15192

Brochure #63-1565

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 GM Truck & SUV 1500

5.3L and 6.2L Installation Instructions

Page 25

106. Remove the ECU splash guard using a 10mm socket

and a panel puller. TIP: Splash guard located next to the

front driver chassis mount.

107. Cutout the supplied template and place it onto the

splash guard. Using a drill with a 1.25” hole saw bit, drill

out the opening in the splash guard.

108. Install the water pump isolator onto the water pump

bracket.

109. Using a 13mm socket, remove two bolts securing the

bumper support brace. TIP: These two bolt locations plus

the bolt securing the ECU splash shield (GREEN) are the

mounting locations for the water pump bracket.

110. Insert the LTR to Water Pump hose through the opening

of the splash guard and reinstall the splash guard using the

push pin. Position the water pump bracket in between the

frame and splash guard and secure the assembly with the

factory hardware. NOTE: Water pump bracket shown

without insulator for photo purposes.

111. Install the LTR to Water Pump hose to the barb

protruding out the side of the water pump. Install the

Recovery Tank to Water Pump hose to the barb protruding

out the top of the water pump. Secure LTR hoses with hose

clamps from Bag #2. Securely install the water pump to the

water pump isolator.