Owners manual

Part #1565, 1566, 1519, 15192

Brochure #63-1565

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 GM Truck & SUV 1500

5.3L and 6.2L Installation Instructions

Page 24

99. Using a 10mm socket, reinstall the hood latch using

the factory hardware. Reconnect the ambient temperature

sensor connector (GREEN).

100. Reattach the ambient temperature sensor to the

support brace so that the sensor is facing the LTR.

101. Reinstall the front grill assembly using the factory

hardware.

102. Using a hose clamp from Bag #2, secure the LTR to

Manifold hose to the front barb on the water crossover.

103. Using a 10mm socket and four (4) M6 x 10mm Hex

Flange bolts from Bag #2, secure the recovery tank bracket

to the recovery tank. Install the Recovery Tank to Water

Pump hose to the bottom barb on the recovery tank and

secure with a hose clamp from Bag #2.

104. Using a 10mm socket, remove two inner bolts securing

the battery tray. Route the Recovery Tank to Water Pump

hose down towards the ECU splash shield. Use the factory

hardware to secure the recovery tank assembly to the

battery tray.

105. Using two hose clamps from Bag #2, secure the

Manifold to Recovery Tank hose to the rear barb on the

water crossover and to the recovery tank.