Owners manual

Part #1565, 1566, 1519, 15192

Brochure #63-1565

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 GM Truck & SUV 1500

5.3L and 6.2L Installation Instructions

Page 20

78. Use a deep 10mm socket to remove six (6) nuts (RED)

and a 13mm socket to remove four (4) bolts (GREEN)

securing the sides of the support brace. Carefully remove

the support brace.

79. Using a panel puller, remove ten (10) push pins

securing the plastic shroud to the support brace. Remove

shroud and set aside.

NOTE: There are two variants of the front support brace.

Variant I has a flat support plate while Variant II has a

support plate with raised sides. If you have variant II,

proceed to Step 80. Otherwise disregard and proceed

to Step 81.

VARIANT II

VARIANT I

80. Using a right angle grinder, or equivalent, trim the

sides of the support plate 35mm from where the plate

meets the brace. The depth of the relief needs to be

approximately 10mm. Deburr all sharp edges with a file

and touch up relief with black paint. Proceed to Step 82.

35mm

10mm