Owners manual

Part #1565, 1566, 1519, 15192

Brochure #63-1565

Rev. 5/17/17 - NP

Edelbrock E-Force Supercharger System

2014-2017 GM Truck & SUV 1500

5.3L and 6.2L Installation Instructions

Page 17

59. Using a 10mm socket, remove the throttle body from

the stock manifold and install it onto the supercharger

manifold using the factory bolts and the supplied throttle

body O-ring gasket. NOTE: Throttle body flange is tapped

for both 5.3L and 6.2L throttle bodies. Verify proper

alignment before securing the throttle body.

60. Connect the supplied ETC extension harness to the

factory throttle body connector. Route the harness under

the supercharger nose and connect to the throttle body.

Secure the ETC extension harness to existing wire looms

and/or hoses away from moving components and sharp

edges.

NOTE: Steps 61-67 will outline the procedure to remove

the front facia on Truck applications. Disregard and

skip to Step 68 if installing on SUV applications.

61. Using a panel puller, remove twelve (12) push pins

securing the top shroud.

62. Using a 10mm socket, remove four (4) bolts securing

the top of the grill assembly.

63. Vehicles equipped with fender guards, use a 7mm

socket and a Torx T15 to remove the front two bolts.

64. Carefully disengage the fender guard by dislodging the

front plastic retaining clips. TIP: Fender guard does not

have to be fully removed.

65. Using a 7mm socket, remove four (4) bolts (two per

side) securing the grill assembly. Proceed to Step 70. TIP:

Fender lining doesn’t have to be removed, but will simplify

this procedure.