Owners manual

©2017 Edelbrock LLC
Part #1565, 1566, 1519, 15192
Brochure #63-1565
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 GM Truck & SUV 1500
5.3L and 6.2L Installation Instructions
Page 16
54. Using a breaker bar, rotate the tensioner
counterclockwise and install the drive belt using the routing
diagram below.
A LT.
IDLER
IDLER
IDLER
S / C
TEN.
CRANK
WATER PUMP
CAUTION: Step 55 must be performed properly to prevent
any driveability issues that may occur.
55. Using the supplied .015” taper jet, position the stem of
the jet into the actuator fitting. Secure the jet to the actuator
by connecting the previously installed actuator hose to the
actuator. Trim the hose to length if necessary.
Stem
56. Using a 10mm socket, remove a bolt and nut securing
the engine harness support right of the new EVAP location.
Carefully lift up the harness support and temporarily
relocate it to access the EVAP solenoid.
57. With the engine harness temporarily relocated, connect
the factory EVAP hose to the EVAP solenoid.
58. Install the straight fitting on the Valley to Nose PCV
hose to the quick connect fitting located at the front of the
valley plate. Connect the 90° end to the quick connect
fitting on the manifold nose.