Owners manual

©2017 Edelbrock LLC
Part #1565, 1566, 1519, 15192
Brochure #63-1565
Rev. 5/17/17 - NP
Edelbrock E-Force Supercharger System
2014-2017 GM Truck & SUV 1500
5.3L and 6.2L Installation Instructions
Page 10
SUPERCHARGER INSTALLATION
WARNING: Battery must be sufficiently charged before
starting the PCM flashing procedure.
Only begin the PCM flashing procedure when you have
downloaded the calibration file from the Edelbrock
Calibration Team to the handheld programmer. Do
not flash the PCM until you are ready to install the
supercharger. Once the PCM is flashed, DO NOT
START the engine until the installation of the E-Force
supercharger is complete.
1. Put the car into ACC mode, but don’t start the vehicle.
2. Connect the supplied PCM cable on the handheld
programmer to the OBD-II connector located below the
steering wheel, and to the left of your knee.
3. Use the directional pad to highlight the Program
Vehicle option and press the Select button.
4. Use the directional pad to highlight the Pre-programmed
Tune option and press the Select button.
5. Read the disclaimer then press Select to continue.
6. Verify that the ignition is in the ‘Key On’ position and
that the engine is not running, then press Select.
7. Use the directional pad to highlight your vehicle and
transmission combination then press Select.
8. Use the directional pad to highlight the Begin Program
option then press Select.
9. Depending on your specific drivetrain configuration,
several separate operations may take place during this
step. Completion of each operation will cause the progress
bar to reset to zero.
10. DO NOT unplug the programmer until prompted.
11. Turn the vehicle off when prompted to do so by the
handheld programmer.
12. Read the parting message from programmer then
press Select to continue.
13. Unplug the programmer cable from the OBD-II port.
This concludes the PCM flashing procedure. DO NOT start
the engine until the supercharger installation is complete.
14. Using a 10mm socket, disconnect the negative battery
terminal.
15. Disconnect the driver and passenger PCV hoses from
the air inlet tube assembly and from the valve covers.