IRELESS I ® sales@eddywireless.com SD Cards Series MDVR USER'S MANUAL V1.07E NO.
Contents CHAPTER 1:PRODUCT APPLICATION AND PARAMETER--------------------------------------1 CHAPTER 2:PRODUCT INTERFACE DEFINITION AND FUNCTION DESCRIPTION-------4 2.1:MDVR Out-design and Dimension--------------------------------------------------------- 4 2.2:Definition of functional MDVR back panel interface----------------------------------- 5 2.3:Definition of simple type MDVR'S back panel interface------------------------------ 6 2.
SD Card Mobile DVR User Manual 1 CHAPTER 1: PRODUCT APPLICATIONS AND PARAMETERS 1.1 MDVR is a cost-effective, function extensibile equipment which is designed for on-board video monitoring and remote monitoring, It uses the rapid handling device and embedded Linux platform, combined with the most advanced H.264 video compression / decompression technology , network technology and GPS technology .
SD Card Mobile DVR User Manual 2 FORM 2 : MDVR BASIC ELECTRICAL PARAMETERS LIST Items Parameters Specifications 8V 36V, When long-term under 8V, or long-term over 36V, Power input DC8-36V auto power off, and enter protection mode. 12V 12V +/-0.2V Max:2A. Power output 4V OFF Vehicle key signal 5V On Impedance 75Ù for each video input impedance 75 Input 2Vp-p CVBS analog signal, reveal device input need 75Ù 2Vp-p Video output Volt impedance to fit <4V Low level alarm I/O interface 4V High level alarm 1.
SD Card Mobile DVR User Manual 3 1.3: MDVR NOTICE: To make sure MDVR safety use, acquire satisfactory performance, and extend the service life of the equipments , please fully consider the following factors when install the equipment : 1.When install and operate the equipment , please obey all the electronic products guide, vehicles' and other connection equipments requirements 2.
SD Card Mobile DVR User Manual 4 CHAPTER 2 : INTERFACE AND DESCRIPTION OF THE FUNCTIONS 2.1 MDVR OUT-DESIGN AND DIMENSION Figure 2-1 Unit mm 138 Figure2-3 47 Panel Indicator Light Description V-OUT Video OUT 162 5 SD1/SD2:Recording SD card Function type MDVR dimension and installation hole site (double SD card indicator light ,Light will be on machine), as shown in Figure 2-1 when the SD card exists.
SD Card Mobile DVR User Manual 5 2.
SD Card Mobile DVR User Manual 6 2.3: DEFINITION OF SIMPLE TYPE MDVR'S BACK PANEL INTERFACE Figure 2-9 GPS Antenna AVIATION HEAD VIDEO & AUDIO INPUT 1--12VOUT 2--GND 3--A-IN 4--V-IN POWER INPUT VIDEO/AUDIO OUTPUT 1: Interface specifications, please refer to table 3, V-in & A-in with aviation head ; 2: 2 channel alarm input , 2 channel alarm output, a pair of school interface; 3: GPS is optional, without 3 G and WIFI function; 2.
SD Card Mobile DVR User Manual 7 3.The yellow cable must be installed on the ignition line , or the equipment will not support the delay shut down , and the last video recording will be missed . 4.The installation of MDVR must get positive electrode directly from the battery. Please don't use iron wire as the ground line . or it will produce negative pulse and jamming the normal operation of the mainframe . The diameter of power supply that the positive electrode and negative pole must above 1.
SD Card Mobile DVR User Manual 8 2.6 INSTRUCTIONS OF FUNCTION KEYS ON REMOTE CONTROLLER Power on /off(not used Temporarily) LOGIN Number key area Picture adjustment PTZ control Direction key area Exit / return Delete/Cancel System information Play back operation key area 4 images segmentation PTZ control key area Shortcut key / test key System information Power on /power off NOTE: this function is not used temporarily If the video has set the password, press LOGIN key to input the password.
SD Card Mobile DVR User Manual 9 CHAPTER 3 SYSTEM MENU SETTING INSTRUCTIONS 3.1: DEMO WORKING AND USERLOGIN. Trun on the device after power supply and otherconnecting successfully and according to installation guidance. Interface refer to Figure 3-1and there are four-image monitoring interface after the device start working.
SD Card Mobile DVR User Manual 10 3.2 SYSTEM MENUS CONSTRUCTION CHART LOGIN SYSTEM BASIC POWER NETWORK PASSWORD RECORD NORMAL CHANNEL TIME LIST VEHICLE SUB-STREAM SENSOR SPEED G-SENSOR TEMPERATURE FORMAT TOOLS PLAYBACK Figure 3-5 SHORTCUT INFO MODULE CINFIGURE UPGRADE LOG DETECTION WIRELESS WIFI PTZ 3.3 SYSTEM SETUP Figure 3-6 Figure 3-7 It is the first menu in the main menu and it includes " BASIC SETUP ;POWER SETUP ;NETWORK SETUP AND PASSWORD SETUP " . 3.
SD Card Mobile DVR User Manual 11 YMD 06:00:00 30 ( 5 MIN 06:00:00 22:00:00 ) Figure 3-8 Figure 3-9 4."COMPANY NAME","VEHICLE NUM","DRIVER NAME""LINE NUM"Setting: Press "Enter" key to pop up keyboard window, then use left/right/up/down/enter key to setup. 5. When turn on automatic adjustment function, in the default time , the system will adjust the time via GPS automatically when it comes to the time for adjustment. 6.
SD Card Mobile DVR User Manual 12 3.4 RECORD SETUP Figure 3-13 Figure 3-12 It includes: Normal setting, Channel setting, timing setting and sub-stream setting. It can reach the highest quality recording after settings. With default settings, the device will start recording after powering on. But in order to reach better recording function, you can modify the related parameters. Record menu is shown as Figure 3-13. 3.
SD Card Mobile DVR User Manual 13 3.4-2 CHANNELS SETUP CH ENABLE RES. FPS QUAL MIC PREVIEW VOLUME CH1 ON D1 25 3 ON ON 15 CH2 ON D1 25 3 ON ON 15 CH3 ON CIF 25 3 ON ON 10 CH4 ON CIF 25 3 ON ON 10 1 Set some properties of each channel,such as RES, QUAl MIC AUDIO,VOLUME etc . FR: 1-25 optional,when reach 25 FR it is real-time recording. 1-8 grade QUA optional, 3 grades is defaulted and 1 is the best, 8 is the lowest.
SD Card Mobile DVR User Manual 14 3.5 VEHICLE INFORMATION Figure 3-19 Figure 3-18 It includes SENSOR, SPEED, G-SENSOR SETUP. SENSOR SETUP Figure 3-20 3.5-1 SENSOR SETUP- ALARM INPUT 1.When users install MDVRs, define the sensors according to different port settings, see the figures 3-20. Like change name "INPUT" to "Front door", "Brakes", and etc. 2."ENABLE" on means switching on the sensor, user can select alarm mode as the recording mode, and then select record and alarm on/off on this menu.
SD Card Mobile DVR User Manual 15 3.5-3 SPEED SETUP GPS VEHICLE KM MPH KM Figure 3-22 1.When setting GPS /VECHILE to get the speed , please press " ENTER " to switch , if select GPS, so should require demo have GPS module and with signal, that can pass the speed to vehicle and the vehicle can get the speed from GPS. 2.
SD Card Mobile DVR User Manual 16 3.6-2 CONFIGURE MANAGE AND LOG SEARCH START TIME 2012-01-15 00:00:00 END TIME 2012-01-15 23:59:59 DATE 12/01/15 12/01/15 12/01/15 12/01/15 TIME 14:45:07 14:46:55 14:55:38 14:56:25 ALL EVENT NAME POWER ON VIDEO LOST1 FILE PLAYBACK REC NORMAL SET Figure 3-28 Figure 3-27 Configure manage mainly including import and outport system current configuration and restore factory configuration.
SD Card Mobile DVR User Manual 17 PROCEDURES OF SETTING DETECTION AREAS: Figure 3-30 Select " Configure " and press " ENTER " , enter into motion detection configurationinterface. (Figure 3-30). Step1 : Select the first Box , press " Enter " gets yellow , after move the arrow keys ,gets dark green ) Step2 : The select second box, the diagonals of the rectangle between these two boxes is the selected area, ( after selected " ENTER " the diagonal region gets into a dark green .
SD Card Mobile DVR User Manual 18 3.7 3.7-1 MODULE MANAGE 3G SETUP INSTRUCTIONS: When device need connect the network , must have setting in this menu . 1)Insert USIM card , which can support two options : China Telecom(WCDMA) and China Mobile (EVDO) USIM card slot is in the communications board , Remove the small plate which under the demo , then can see the USIM slot , detail installation information please refer to 2.5 section .
SD Card Mobile DVR User Manual 19 3.7-2 WIFI SETUP WIFI SETUP ENCRYPT TYPE:WEP ENABLE ENCRYPT AUTH MODE ENCRYPT TYPE SSID PASSWORD ON ON OPEN IP ADDR 192.168.001.012 NETMASK 255.255.255.000 GATEWAY 192.168.001.001 WEP WIFI SETUP SAVE Figure 3-36 INSTRUCTIONS: Insert WIFI antenna into the backside mount of the demo , Edith the following information at the interface as pictures (Figure 3-36) 1.Make enable and Encrypt status" ON " authentication mode including WPA , WPA-PSK,OPEN and share.
SD Card Mobile DVR User Manual 20 8. Remote control opertation Setting " " on the manu . They are used for controlled up down ,left and right " ZOOM " " + " , " - " enlarge and narrow function " Focus " " + " , " - " Transfer large focal length and transfer small focal length. " IRIS+ "," IRIS- " Adjust infrared ights, " PRESET " used for setting preset position, " RECALL " Used for select to use preset position, " BRUSH " is wiper. These function only can achieved once PTZ available.
SD Card Mobile DVR User Manual 21 Normal setup Record mode. Others manus such as sensor setting , speed alarm setting, shock acceleration,motion detection set related parameters and also connect peripherals, when alarm signal occurs,system will record the video automatically.when playback the recording, resolution contains D1/HD1/CIF, Video' s starting and ending timeis the file package time and it will show file' s storage SEARCH RESULT DATE 2012-01-01 TYPE RES.
SD Card Mobile DVR User Manual 22 CHAPTER 4: COMMON SHORTCUT SETUP 4.1 CABLES TESTING AND POWER ON The host power cable has three wires red, black and yellow. Red and black wires connect to the car battery directly,red wire to positive pole and black to negative pole.The yellow wire directly connects to the ignition wire (namely the gear before the start-up motor).
SD Card Mobile DVR User Manual 23 alarm preparation record time (range 0-60s) and the alarm record delay time (range 30-900s); the alarm output time (range 5-240s), the alarm output setting can be dependent on the actual external alarm equipment. Second, the installation of corresponding external alarm input devices is needed, like emergency switch button, switch door magnetic door, sudden braking sensor and other sensors.
SD Card Mobile DVR User Manual 24 4.3 PTZ CONNECTION AND SETUP Setup steps: Step 1, Choose PTZ protocol, includes PELCO-D and PELCO-P, mostly choose PELCO-D. Step 2, Setup baudrate from 1200/2400/4800/9600, which has to correspond to that on PTZ. Step 3, Setup PTZ address, which should match the set address on PTZ, Normally the default PTZ address is 1. The dialed address of PTZ is adjustable, and can set differently to identify if more PTZ are used.
SD Card Mobile DVR User Manual 25 4.4 PLAYBACK RECORDED FILES ON PC Recorded files can not only playback on the device itself,but also can transfer to the PC player to play.Install the player: Double-click the CD-ROM installation files" MDVR PLayer V1.0.1.30_111221.exe" , and select the installation language, which supports Chinese and English, then click OK and click 'Next'.
SD Card Mobile DVR User Manual 26 4.5 VEHICLE FAST CONNECTING TO CMS NOTE: For the Simply MDVR which without WIFI and 3G modules, the below instructions is not compatible to them Step 1: Install SIM card which support WCDMA/EVDO. Please refer to Section 2.6 for detailed installation steps reference, as shown in Figure 2-15. Step 2: Enter into system menu after booting, modify the host ' s device number from 00000 to 99999 firstly, SYSTEM MENU - SETUP-BASIC- SETUP VEHICLE NUM.
SD Card Mobile DVR User Manual 27 Mode is workable without authentication,For encryption type, need to choose WEP, then insert SSID and password (wireless network's name and password). Also need to set the host IP address, mask, gateway and etc. With settings finished, press the" F1 " button on the remote control, Check the WIFI signal and check whether the current host is in the current local area network via PC ping. 192.168.001.125 255.255.255.000 192.168.001.
SD Card Mobile DVR User Manual 28 APPENDIX 2: FAQ Q: What should I do if problems occur when I can not solve myself? A: Please write down the units number, software version number and describe theproblems in details, then submit to our technical support for analysis. Please kindly note that the more detailed descriptions that you offer will make our analysis more convenient. Q: There' s no video output from the Mobile DVR? A: 1.
SD Card Mobile DVR User Manual 29 FAQ ABOUT 3G (Basic SD card MDVR without 3G/WIFI modules ,Please notice the bellowing points: ) Q: What need I pay attention on using 3G wireless module to dial? A: 1.Built-in wireless module is different between WCDMA and EVDO, also different devices support different modules. Please make sure that your module matches with the USIM card inserted. Never use EVDO USIM cards insert WCDMA device. 2.
SD Card Mobile DVR User Manual 30 APPENDIX 3: CORRESPONDING TABLE OF STORAGE SPACE Corresponding table between image quality and recording space Quality Resolution Storage Space The storage space for one channel per hour is as showing as the above table for reference. The actual recording file size is depending on the current channel, illumination variant, object movement and many other factors.