E-TILESHARK-I-0913 Operator’s Instruction Manual TILE SHARK 8” Electric Tile Stripper 100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA Phone (301) 663-1600 • 1-800-638-3326 Fax (301) 663-1607 • 1-800-447-3326 Website: www.edcoinc.com • Email: sales@edcoinc.
E-TILESHARK-I-0913 READ AND UNDERSTAND THE OPERATORS INSTRUCTION MANUAL THOROUGHLY BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT. Death or serious injury could occur if this machine is used improperly. SAFETY SAFETY MESSAGES • MESSAGES Safety Instructions are proceeded by a graphic alert symbol of DANGER, WARNING, or CAUTION. Indicates an imminent hazard which, if not avoided, will result in death or serious injury. Indicates an imminent hazard which, if not avoided, can result in death or serious injury.
E-TILESHARK-I-0913 Equipment Instruction Manual EDCO Model TILE SHARK Table of Contents Section Page Number Safety Guidelines ............................................................................................................4 Operating Instructions ....................................................................................................5-6 Changing the Blade .........................................................................................................6 Maintenance ........
E-TILESHARK-I-0913 Read and understand all operating instructions before operating this equipment. Death or serious injury can result if this machine is used improperly. Safety Guidelines Eye and ear protection must be worn at all times while the Tile Shark is in use. During normal operation, sound pressure levels less than 85dBA. Use only ANSI approved safety glasses to help prevent eye injury. Everyday eyeglasses have only impact resistant lenses; they are NOT safety glasses.
E-TILESHARK-I-0913 A) On/Off Switch Operating Instructions B) Angle Adjustment C) Blade Holder I D D E A D) Cushioned Grips for Greater Operator Comfort J B Note: Raise handle (I) slightly to release downward presF) Oversized Wheels for Easy sure on angle adjustment mechanism before attemptManeuverability ing blade angle adjustment.
E-TILESHARK-I-0913 Starting the Machine: • Make sure the machine is clear of walls and/or obstructions, tilt it back slightly to shift the weight onto the wheels, then turn the switch to ON. (Figure 3) • • Do not force the machine. Shut the machine OFF when repositioning for another pass. Cutting: • The TileShark is equipped with a 2 position handle bracket. Rear slot for normal removal. Front slot for aggressive removal.
E-TILESHARK-I-0913 Read and follow instructions in the engine owner’s manual. Repairs are to be done by authorized EDCO Dealers only. Maintenance Disconnect the power source at the machine and remove blade before performing any maintenance. Grease striker plate driven shaft bearing every 4 hours of use. (Figure 7 & 7A). Use Lubriplate #1444 High Temperature grease or equivalent. • Lubricate the wheel bearings from time to time with an occasional drop or two of oil to prevent binding.
E-TILESHARK-I-0913 LIMITED EQUIPMENT WARRANTY OF SALE – TERMS & CONDITIONS Equipment Development Company, Inc. herein referred to as EDCO (Seller) warrants that each new unit manufactured by EDCO to be free from defects in material and workmanship in normal use and service for a period of (1) one year (except for the cutter drum assembly on all model concrete/asphalt planes, in which case the warranty period shall be 90 days) from date of shipment to the original retail or equipment rental center owner.
