Owner's manual

Printed in USA
TVW ©2005
Page 13
E-CPU10FC-I-0905
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone [phone] • 1-800-638-3326
Fax [phone] • 1-800-447-3326
Website: www.edcoinc.com • Email: [e-mail]
• On new equipment, and after replacing a set of belts, they should be re-tensioned after the rst four hours of use.
• New belts will be stiff and will loosen with use. Proper belt tension must be maintained to transmit the engine
power to the cutting drum. Slipping belts will overheat, the blade life will be shortened and the cutting speed lim-
ited. Over tensioned belts will shorten the belt and bearing life.
• Damaged, stretched or excessively worn belts should be replaced with a new matched set.
• To tension belts, loosen motor mounting hardware slightly. Use the jacking bolt to adjust the motor until the belts
are tight. Re-torque the engine mounting hardware.
Belts:
Jacking Bolt and Engine Mounting Hardware
Belts
• Check oil level before operation. Change engine oil and lter according to engine manufacturers recommenda-
tions.
• Clean air lter element daily.
Important!