Owner's manual

Printed in USA
©2005 TVW
Page 12
E-CPU10FC-I-0905
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone [phone] • 1-800-638-3326
Fax [phone] • 1-800-447-3326
Website: www.edcoinc.com • Email: [e-mail]
Never work on or under equipment without rst securing the equipment to prevent it from mov-
ing or falling. Always work on a at and level surface.
Refer to the Engine Manufacturer’s Owner’s Manual
for maintenance information specic to the engine used.
Grease cutter assembly bearings (2)
after every 4 hours of use.
IMPORTANT!
• Grease Depth Control Bearing every 40 hours.
• Check hydrostatic transmission uid level after
every 50 hours of operation. If it is low, ll to
level mark with GM Dexron B or comparable
uid.
Grease wheel bearings every 40 hours
Remove both spark plug leads on gasoline engine models or
disconnect the supply voltage connector on
electric models before performing any maintenance.
Disconnect the power cord at the machine.
Maintenance Instructions
Cutter Assembly
Bearings (2)
Depth
Control
Bearing
Transmission
Fluid