Use and Care Manual

CPL8-CPM-4-8-10-I-0416
Page 8
800-638-3326 • edcoinc.com • [e-mail]
EQUIPMENT DEVELOPMENT CO., INC.
CUTTING
Starting the Cut:
• Slowly lower the cutter head to the slab surface with the cutter head lever.
(Figure 2, Item 1) & (Figure 4)
• Lift the knob of the Depth Control to unlock and turn the hand wheel slowly
until the cutter head contacts the slab (you will hear the sound of the cutter
wheels contacting the slab). Continue adjusting the depth of cut until the
desired depth is reached; max depth of cut 3/8” (9.5 mm).
• Use an Industrial Vacuum Dust Control System for dry planing operations.
• Optional water hookup also available.
To Stop Cutting:
• Move cutter head control lever to raise cutter head assembly above slab surface.
• For gasoline and propane models, close throttle and turn the ignition switch to the “off” position.
• For electric models, depress the “OFF” button.
After Cutting:
• At the end of the day, clean the entire machine after it has cooled. Check for worn or damaged cutters and per-
form any required maintenance. See Maintenance Schedule page 19 and Instructions on page 17.
• If water was used for dust control - - - clean slurry under machine before it drys.
Figure 4