Use and Care Manual

CPL8-CPM-4-8-10-I-0416
Page 17
800-638-3326 • edcoinc.com • [e-mail]
EQUIPMENT DEVELOPMENT CO., INC.
Never work on or under equipment without rst securing the equipment to prevent it from mov-
ing or falling. Always work on a at and level surface.
Refer to the Engine/Motor Manufacturer’s Owner’s Manual
for maintenance information specic to the engine/motor used.
Grease cutter assembly bearings (2 ea)
after every 4 hours of use.
IMPORTANT!
Remove spark plug lead on gasoline/propane engine models
or disconnect the supply voltage connector on
electric models before performing any maintenance.
Disconnect the power cord at the machine.
Maintenance Instructions
Grease Depth Control grease point
every 40 hours.
Depth Control
Grease point
all models. Bearing
Jacking Bolt
CPM 8 & 10
CPL-8
Wheel
Depth Control
Multi Vac Port
CPM-8 Electric
Power Switch
Manual Reset
Button
Multi Vac Port
Cutter assembly
bearings (2)
CPM-4