Manual

E-CPL8-CPM-4-8-10-I-0112
Printed in USA
©2012 TVW
Page 8
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: sales@edcoinc.com
CUTTING
Starting the Cut:
• Slowlylowerthecutterheadtotheslabsurfacewiththecutterheadlever.
(Figure 2, Item 1) & (Figure 4)
• LifttheknoboftheDepthControltounlockandturnthehandwheelslowly
until the cutter head contacts the slab (you will hear the sound of the cutter
wheels contacting the slab). Continue adjusting the depth of cut until the
desireddepthisreached;maxdepthofcut3/8”(9.5mm).
• UseanIndustrialVacuumDustControlSystemfordryplaningoperations.
•Optionalwaterhookupalsoavailable.
To Stop Cutting:
• Movecutterheadcontrollevertoraisecutterheadassemblyaboveslabsurface.
• Forgasolineandpropanemodels,closethrottleandturntheignitionswitchtothe“off”position.
• Forelectricmodels,depressthe“OFF”button.
After Cutting:
• Attheendoftheday,cleantheentiremachineafter it has cooled. Check for worn or damaged cutters and per-
form any required maintenance. See Maintenance Schedule and Instructions on page 13.
•Ifwaterwasusedfordustcontrol---cleanslurryundermachinebeforeitdrys.
Figure 4
Cutters Clear of
Slab Surface
Cutter Drum
Cutter Wheel
Disengage
Lever
UP
Position
Depth Adjustment Crank
UP