Owner's manual

E-2ECGCNG-I-0513
Printed in USA
©2013
Page 13
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone [phone] • 1-800-638-3326
Fax [phone] • 1-800-447-3326
Website: www.edcoinc.com • Email: [e-mail]
Dyma-Serts™ (Patented)
DYMA-SERTS™ are diamond segments welded to snap-
in plates for faster, controlled, dry grinding, and are ideal
for removing trowel marks, rough nish, rain spots, large
volume projects, paints, thin mastics, epoxy and urethane
coatings, or polymer enhanced surfaces. DYMA-SERTS™
can be used wet or dry and will outperform stones by
grinding many times faster, removing tough materials, and
lasting many times longer - up to 30,000 sq. ft. (2,800 sq.
meters) life (at 1/32”) dependent on depth of removal, coat-
ings, speed of operation, matrix, etc. Extra weight can be
added to the grinder to increase production. Choose the
DYMA-SERT™ to t your job.
STRIP-Serts™ Are carbide-tipped blocks designed
to clean oors without grinding into the concrete. The multi-
sided, replaceable tungsten carbides have four edges that
can be rotated for maximum use. The carbide Strip-Serts™
will clean your surface without any damage.
DOUBLE DIAMOND DOTS General Purpose
Grind - Removes General Purpose Epoxy, Matsics, Thin-
sets, Water-proong Coatings and more. Use with the 7”
and 10” Quick-Change Multi-Accessory Discs.
PCD ACCESSORY Extremely aggressive remov-
al. Digs through Industrial Strength Coverings, Water Proof-
ing Membrane, Thick Epoxies and Much more. Leaves a
textured concrete surface.
This is a Double Diamond Dots.
This is a PCD.
FOR USE WITH QUICK-CHANGE MULTI-ACCESSORY DISC
Spring clip
This is a DYMA-SERT, rotate the DYMA-SERT
only, not the case.
Accessory
case
This is a STRIP-SERT, rotate this blade to
expose a new cutting surface. There are four
(4) cutting surfaces on each blade.
Use a hex wrench to remove hex screw to allow
rotation of blade.