Product Manual

SE-601 Series Electrocardiograph User Manual System Setup
- 87 -
9.5 Transmission Setup
NOTE: To transmit ECG data to the PC, the Smart ECG Viewer software of the
manufacturer must be installed in the PC.
Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor to Transmission on the System
Setup screen, and then press Enter to open the Transmission Setup window.
In the Transmission Setup window, you can set Transmission Mode, Remote IP, Local IP,
Gateway and Subnet Mask.
Figure 9-11 SE-601B / SE-601C Transmission Setup Window
Figure 9-12 SE-601A Transmission Setup Window
To Specify Transmission Mode
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Transmission Mode item,
and then press F1 or F2 to select Off, Ethernet or UART.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Transmission Mode
item, and then press F3 or F4 to select Off, Ethernet or UART.
When Transmission Mode is set to Off, ECG data can not be transmitted.
When Transmission Mode is set to Ethernet, first connect the net port of the electrocardiograph
to the net port of the PC by using an Ethernet cable recommended by the manufacturer. Log into
the Smart ECG Viewer software. Then set all the items in the Transmission Setup window. In the
AUTO or RHYT mode, ECG data can be transmitted through the net port automatically after
ECG reports are printed.
When Transmission Mode is set to UART, first connect serial port of the electrocardiograph to
the serial port of the PC by using a serial cable recommended by the manufacturer. Log into the
Smart ECG Viewer software. In the AUTO or RHYT mode, ECG data can be transmitted
through the serial port automatically after ECG reports are printed.