Product Manual

SE-601 Series Electrocardiograph User Manual System Setup
- 85 -
In the AUTO mode, when Analysis is set to On, the auto diagnosis information will be printed in
the ECG reports.
In the AUTO mode, when Analysis is set to Off, the auto diagnosis information will not be
printed in the ECG reports.
9.3.10 Selecting Position Marker
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Position Marker item in the
Record Setup window, and then press F1 or F2 to select Off or On.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Position Marker item
in the Record Setup window, and then press F3 or F4 to select Off or On.
In the AUTO mode, when Position Marker is set to On, the position marker will be printed
while printing template, and the time ruler will be printed on the bottom of ECG reports, which
indicates whether Record Sequence is Sequential or Simultaneous. For details of the recording
sequence, please refer to Section 9.1.6, “Specifying Recording Sequence”.
In the AUTO mode, when Position Marker is set to Off, the position marker and the time ruler
will not be printed in the ECG reports.
NOTE: To get more information about the above contents, please refer to Section 7.7,
“ECG Reports”.
9.4 Lead Setup
Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor to Lead on the System Setup screen,
and then press Enter to open the Lead Setup window.
In the Lead Setup window, you can set Rhythm Lead1/2/3 and Lead Sequence.
Figure 9-9 SE-601B / SE-601C Lead Setup Window