Product Manual

SE-601 Series Electrocardiograph User Manual System Setup
- 81 -
NOTE:
1. During the USB printing course，pressing the START/STOP key again can not stop
printing ECG reports.
2. USB printing only works in the auto real-time sampling mode, auto pre-sampling
mode, and auto trigger sampling mode. It also supports copy printing, and file printing
in the AUTO mode on the File Manage screen.
3. Make sure that paper is installed in the USB printer before printing. Error may occur if
no paper is loaded in the USB printer.
CAUTION
1. In order to protect the USB printer, you should connect the USB printer after power-on,
and disconnect the USB printer before power-off.
2. It is forbidden to frequently connect or disconnect the U disk or the USB printer
afterpower-on.
9.3.2 Setting Paper Marker
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Paper Marker item in the
Record Setup window, and then press F1 or F2 to select an option.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Paper Marker item in
the Record Setup window, and then press F3 or F4 to select an option.
Paper Marker is used to identify the paper style.
When the paper with black markers on the bottom is used and Paper Marker is set to Style1 or
Style2,
1) In the AUTO or RHYT mode, the device rolls back the recorder paper to the start point
of each page at the beginning of the printing course, and it advances the paper to the next
black marker at the end of the printing course.
2) Before printing, you can press the Space key to advance the recorder paper to the next
black marker.
When Paper Marker is set to Style1, only the paper with black markers around the bottom left
corner of each page can be used, which is shown in the following figure.