Product Manual

SE-601 Series Electrocardiograph User Manual System Setup
- 80 -
Figure 9-7 SE-601B / SE-601C Record Setup Window
Figure 9-8 SE-601A Record Setup Window
After setup, press Enter to confirm. Then the System Setup screen appears.
For SE-601A, if you press Esc to exit the Record Setup window after setup, a hint will pop up to
prompt you to save these modifications.
NOTE: The Patient Info, Template, Measure, Minnesota Code, Analysis, and
Position Marker items are valid only in the AUTO mode.
9.3.1 Specifying Recording Device
For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Record Device item in the
Record Setup window. Press F1 or F2 to select an option.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Record Device item in
the Record Setup window. Press F3 or F4 to select an option.
You can set Record Device to Thermal, HP Deskjet D2468, HP Deskjet D5568, HP Deskjet
D2668, HP Deskjet D4368 or HP Laserjet P2035. The last five options are the types of the USB
printer, when any of them is selected, you should connect the corresponding USB printer to USB
socket 2 of the electrocardiograph with a special cable. Press the START/STOP key to print
ECG reports by using the USB printer.
WARNING
If the printer used is not the type listed above, additional safety measures (such as
applying an isolation transformer to supply the medical system) should be taken when the
safety of the medical system has not been evaluated. If in doubt, consult our technical
service department or your local distributor