Product Manual

SE-601 Series Electrocardiograph User Manual Entering Patient Information
- 41 -
Chapter 6 Entering Patient Information
After the electrocardiograph is switched on, the main screen1 appears.
6.1 Entering Patient ID
1. By default, the system generates the patient ID automatically. The range of the patient ID is 0
~ 1999, 999, 999.
2. Or the system can generate the patient ID according to the current time.
The procedures are as follows:
1) Press the function key F5 below to display the main screen2.
2) Press the function key F1 below Setup to open the System Setup screen.
3) Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor. When the cursor is on Pat.
Question, press Enter to open the Patient Question window. The cursor is on the ID
Mode item.
4) For SE-601B/C, press F1 or F2 to select Time. For SE-601A, press F3 or F4 to select
Time.
5) Press Enter to confirm.
6) Press Esc or the function key F5 below to return to the main screen1.
Then the system will generate the patient ID according to the time when you press the
START/STOP key to print an ECG report.
3. Or you can enter the patient ID manually.
The procedures are as follows:
1) Press the function key F5 below to display the main screen2.
2) Press the function key F1 below Setup to open the System Setup screen.
3) Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor. When the cursor is on Pat.
Question, press Enter to open the Patient Question window. The cursor is on the ID
Mode item.
4) For SE-601B/C, press F1 or F2 to select Manu. For SE-601A, press F3 or F4 to select
Manu.
5) Press Enter to confirm.
6) Press Esc or the function key F5 below to return to the main screen1.
7) Press the function key F1 below Patient to open the Patient Information window. Press
Tab or Shift + Tab to move the cursor. When the cursor is in the ID textbox, enter the
patient ID manually.
8) Press Enter to confirm.