Product Manual

SE-601 Series Electrocardiograph User Manual Operation Preparations
- 30 -
Please refer to the maintenance section for how to recharge the battery. When the battery
is being recharged, the electrocardiograph can be powered by the mains supply.
WARNING
Potential equalization bar of the unit should be connected to the potential equalization
terminal of the electrical installation when necessary.
CAUTION
1. If the electrocardiograph is turned off automatically because of low battery capacity,
the settings may not be saved.
2. If the battery has been fully charged and requires recharging after printing only a few
ECGs, consider replacement.
3. The use of electrocardiograph accessories (such as barcode reader) will deplete
battery power at a faster rate. The battery will require more frequent charging if these
accessories are used with the electrocardiograph.
4.2 Loading/Replacing Recorder Paper
The recorder paper is the folded thermal paper.
NOTE: The exit edge can help you tear the recorder paper.
CAUTION
Make sure that the recorder paper is installed in the center of the recorder, and the paper
edge is parallel with the casing edge in the direction of advancing paper, in order to avoid
paper deviation or damage to the paper edge.
When the recorder paper runs out or is not loaded, or the casing is not closed properly, the hint
message No Paper appears on the screen. Then you should load or replace the recorder paper
immediately.