Product Manual

SE-1200 Series Electrocardiograph User Manual System Setup
- 115 -
Options Corresponding USB Printers
HP Deskjet 3938
HP Deskjet D2368
HP-DJ-D2468
HP Deskjet D2468
HP Deskjet D2568 HP-DJ-D5568
HP Deskjet D5568
HP Laserjet P2015 HP-LJ-P2035
HP Laserjet P2035
NOTE:
1. During the USB printing course，pressing the START/STOP key again can not stop
printing ECG reports.
2. For details of the ECG report printed by the USB printer, please refer to Section 8.6.5,
“ECG Reports Printed by the USB Printer”.
3. USB printing is ineffective in the auto periodic sampling mode, auto 11~24s sampling
mode, manual mode and R-R analysis mode.
4. Make sure that paper is installed in the USB printer before printing. Error may occur if
no paper is loaded in the USB Printer.
CAUTION
It is forbidden to frequently connect or disconnect the U disk or the USB printer.
11.3.1.6 Setting Speed
Press Tab or Shift + Tab to move the cursor to the Speed list box on the Setup 1 tab, and then
press the Up or Down arrow to highlight an option.
In the manual mode, you can set Speed to 5mm/s, 6.25mm/s, 10mm/s, 12.5mm/s, 25mm/s or
50mm/s. In the auto and rhythm modes, only 25mm/s and 50mm/s are available. In the R-R
analysis mode, only 25mm/s is available.
11.3.1.7 Selecting Paper Marker
Press Tab or Shift + Tab to move the cursor to the Paper Marker list box on the Setup 1 tab,
and then press the Up or Down arrow to highlight No or Yes.
Paper Marker is used to identify the start point of each page of the recorder paper.