Product Manual

SE-1200 Series Electrocardiograph User Manual Managing Files
- 96 -
10.1.2 Transmitting DAT Files through Net Cable
1. Connect the electrocardiograph to the network of the PC with an Ethernet cable recommended
by the manufacturer.
If the wireless AP transmission is used, connect the PC to the server wireless AP, and connect
the electrocardiograph to the client wireless AP. Only the wireless AP recommended by the
manufacturer can be used.
NOTE:
1. For details on configuring the wireless AP, please refer to the user manual delivered
with the wireless AP.
2. There should be no shield in or around the room where the wireless AP is used, or
else the wireless transmission may fail.
2. Log into the Smart ECG Viewer software.
NOTE: If you don’t connect the electrocardiograph to the network of the PC (or if you
don’t connect the electrocardiograph/PC to the wireless AP), or you do not log
into Smart ECG Viewer before transmission, the following hint will pop up.
3. Set Transmission Mode to Ethernet in the Transmission Setup window. Set the IP addresses.
For details on setting the transmission mode and the IP addresses, please see Section 9.1.2,
“Transmitting ECG Data in DAT Format Through Net Cable”.
4. Press the function key F7 below File to display the File Manager screen1.
5. Press the function key F1 below Trans All to transmit all the files to the PC. After all the files
are transmitted, the following hint will pop up.